Mold - Jar Casting Mold - for Epoxy, Clay or other casting medium
$10.00
Jar Casting Mold - Silicone Mold, makes a small Cork Jar, for Epoxy, Clay, or other casting medium.
Nicely shaped and sturdy mold for casting, makes a small Jar for however you want to use it.
Finished Jar is approximately -- 3 inches tall and 2.5 inches wide, holds about 1 liquid ounce ( 30 ml).
Finished Jar takes Cork Size -- # 24 -- offered as an add on for the mold, in packets of 3 corks.
the mold and corks listed here are sold separately, please be sure to add the corks if you wish them included.
opening on finished jar is 42mm, and you may be able to obtain, or craft alternative closures for that size.
included corks are size 24, but very short length.
This Mold is a bit tricky to get out and de mold, recommended for intermediate or advanced casters, or beginners with a higher tolerance for possible failure =).
it is certainly possible, but do wait extra time until project is completely dry, as it will take quite a bit of pull and strain to remove from mold.
additional tip - place mold upside down in plastic disposable cup (or any cup) to reinforce the mold before casting. this will help hold the perfectly round shape and provide a sturdy set up for your casting project.
Free Shipping on any additional items in my shop, pay one flat shipping fee no matter how many items you order.
Nicely shaped and sturdy mold for casting, makes a small Jar for however you want to use it.
Finished Jar is approximately -- 3 inches tall and 2.5 inches wide, holds about 1 liquid ounce ( 30 ml).
Finished Jar takes Cork Size -- # 24 -- offered as an add on for the mold, in packets of 3 corks.
the mold and corks listed here are sold separately, please be sure to add the corks if you wish them included.
opening on finished jar is 42mm, and you may be able to obtain, or craft alternative closures for that size.
included corks are size 24, but very short length.
This Mold is a bit tricky to get out and de mold, recommended for intermediate or advanced casters, or beginners with a higher tolerance for possible failure =).
it is certainly possible, but do wait extra time until project is completely dry, as it will take quite a bit of pull and strain to remove from mold.
additional tip - place mold upside down in plastic disposable cup (or any cup) to reinforce the mold before casting. this will help hold the perfectly round shape and provide a sturdy set up for your casting project.
Free Shipping on any additional items in my shop, pay one flat shipping fee no matter how many items you order.
